Posted by Mark Lyons on December 05, 2002 at 10:59:07:
In Reply to: melted lead came accidently posted by Susan on November 28, 2002 at 10:33:07:
: Help! I melted through my frame and I don't know if it can be fixed. It's a small hole, but still a hole where one shouldn't be. Any ideas?
I have had the same problem a few times. I handled it by cutting the damamged section out at a glass joint and simply replacing it with new came. The piece I was making was very light so support was not an issue. You could always start from scratch. Good luck.